Magtek eDynamo, Programmer'S Manual

Page: 88 / 245

8 - Commands
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 88 of 245 ( D998200115-17 )
8.3.14 Command 0x48 - Notification Output Connection Override (Bluetooth LE Only |
Lightning Only, USB Only)
The host uses this command to immediately and temporarily override the current setting in Property
0x5F - Notification Output Connection (Bluetooth LE Only | Lightning Only, USB Only ) until the
device is power cycled or reset, changing the connection the device uses to send Magnetic Stripe Card
Data Sent from Device to Host [see section 2 Connection Types ] and Notification Messages Sent
from Device to Host (Extended Notifications Only) to the host.
If the host does not specify a connection type in the request, the response’s Connection value returns the
current connection type, otherwise the response contains no additional data.
Table 8-30 - Request Data for Command 0x48 - Notification Output Connection Override (Bluetooth LE
Only | Lightning Only, USB Only)
Offset Field Name Description
0 Connection
0x00 = USB
0x01 = Bluetooth LE (Bluetooth LE
Only)
Table 8-31 - Response Data for Command 0x48 - Notification Output Connection Override (Bluetooth LE
Only | Lightning Only, USB Only)
Offset Field Name Description
0 Connection
0x00 = USB
0x01 = Bluetooth LE (Bluetooth LE
Only)
Result codes:
0x00 = Success
Example Request (Hex)
Cmd Num Data Len Data
48 01 01
Example Response (Hex)
Result Code Data Len Data
00 00