Magtek eDynamo, Programmer'S Manual

Page: 145 / 245

9 - Properties
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 145 of 245 ( D998200115-17 )
9.12 Property 0x15 - MagnePrint Flags (MSR Only)
Property ID:
0x15
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property:
Yes
Default Value: 0x00
The host uses this property to direct the device to either include or exclude MagnePrint data in
Magnetic
Stripe Card Data Sent from Device to Host (MSR Only | Keypad Entry Only) when the device is in
Security Level 2 . At higher security levels, the device always sends encrypted MagnePrint data.
Bit Position 7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 S
S = 0: Device does not include MagnePrint Data
S = 1: Device includes MagnePrint Data
Setting S to 1 directs the device to send
MagnePrint Status , MagnePrint Data Length (HID | GATT |
SLIP) , MagnePrint Absolute Data Length (HID | TLV | GATT | SLIP) , and Encrypted MagnePrint
Data with each swipe when it is in Security Level 2 .
Setting S to 0 directs the device to zero-fill these values.
Some devices are configured to only allow the manufacturer to modify this property.
This property is stored in non-volatile memory, so it persists when the device is power cycled. When this
property is changed, the device must be reset (see
Command 0x02 - Reset Device ) or powered off for at
least 30 seconds, then powered on, before the changes will take effect.