Magtek DynaPro Go, Programmer'S Manual

Page: 172 / 247

Appendix F - Error Codes
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer’s Manual (COMMANDS)
Page 172 of 247 ( D998200136-31 )
F.6 Device Offline W Codes (802.11 Wireless Only)
Table 4-110 - "W" Error Codes
Code
Displayed
Description Comments
W01 NET_STATUS_INTIATE_NOK
The device has sent Report 0x2F - Request
Host Connection (Handheld Operation
Only, 802.11 Wireless Only)
but the host
has not responded as expected / at all.
W02 NET_STATUS_AP_DISCONNECTED 802.11 wireless access point disconnected.
W03 NET_STATUS_NO_IP
Device is connected to an 802.11 wireless
access point, but has not been assigned an IP
address.
W04 NET_STATUS_AP_CONNECTION_NOK
Device could not connect to 802.11 wireless
access point. Usually passcode is incorrect,
WPA2 mode not enabled.
W05 NET_STATUS_AP_NOT_FOUND
Device could not find the configured access
point. Either the SSID is not configured
correctly, or the access point is not set to use
the 2.4 GHz band, or the access point does
not support 802.11b,g, or n.
W06 NET_STATUS_HOST_CONFIG_NOK
The device’s connection information for the
host is not configured properly.
W07 NET_STATUS_CLIENT_HOST_NOK
The device could not reach a host when
attempting to initiate a connection (host not
running, Host IP Address or DNS Name set
incorrectly, host port incorrect).
W08 NET_STATUS_SERVER_CONFIG_NOK Reserved
W09 NET_STATUS_SOCKET_NOK
Socket error: Device cannot open socket, the
TLS configuration may not be the same on
device and host, or the command packet
does not follow SLIP protocol.
W10 NET_STATUS_TLS_NOK
The device has certificates loaded that are
not valid for its TLS connection.
W11 NET_STATUS_SYS_NOK System error. Reset the device.
W12 NET_STATUS_SELFTEST_NOK
The device’s 802.11 wireless firmware is
corrupted: Update the wireless firmware.