4 - Command Set
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer’s Manual (COMMANDS)
Page 147 of 247 (
D998200136-31
)
4.6.4.2
Command 0xE4/0x02 Set 802.11 Wireless Access Point Security Key/Password
This command sets the security key/password the device should use to connect to the 802.11 wireless
network access point.
For connection type
Personal Network
, this sets the pre-shared key (PSK) for the access point.
The host must use the USB connection to call this command, and must first successfully unlock the
device’s 802.11 wireless settings by calling
Command 0xE1 - Unlock Wireless Network
Configuration (802.11 Wireless Only)
Table 4-94 - Usage Table for Command 0xE4 –Set 802.11 Wireless Access Point Security Key/Password (Set
mode)
Bit
7
6
5
4
3
2
1
0
Byte 0
0xE4
Byte 1
Setting ID:
0x02 = Access Point Security Key / Password
Byte 2
Security Key length
Bytes 3..63
Security Key (up to 61 characters)
