MCC-35
21
5.3.4.2 Create A Job With Smart Input:
5.3.4.2.1 Input Lead Trim
Press Mode Key
for 4 times to enter Smart Input. Input value 30 and
press Enter to confirm, and then go to the Card Length & Gutter Screen.
The Trim range is 3.2~48. Since the first cut range is 3.2~15, the lead trim will
be divided into some cuts which is in the range from 3.2 to 15. The lead trim 30
will be divided into two cuts 15 wide.
5.3.4.2.2 Input Card Length & Gutter
Input value 200 and press Enter to confirm.
Input value 10 and press Enter to confirm.
The Gutter Cut range is 3~15.
5.3.4.2.3 Input Crease Data
The crease data is based on the finished cards rather than the lead edge of
paper sheet. Crease in the middle and card length is 200, so input value 100
and press Enter to confirm. The max crease in smart input mode is 4 lines.
When crease 2 is 0, the next screen (crease 3 and crease 4) will not appear.
Summary of Contents for MCC-35
