Magnimage LED-W4000, User Manual, Page: 22 / 83

18
Default status introduction
After power on the LED-W4000 series processor, the boot interface will be
displayed on the LCD screen of the front panel during system start up. After
the start-up is completed, the main interface of the current machine will be
displayed as the default state, as shown below.
Figure 1 default status interface after power on.
Input 1 1920×1080
Input 2 1920×1080
Input 3 No Signal
Input 4 No Signal
Input 5 4096×2160
Input 6 DVI DP SDI
HDMI DP DVI
DVI DP HDMI
HDMI DP DVI
Outpu Mode： DVI Mode
Working Mode： Mosaic
HDMI DP
DVI 2A DVI 3A DVI 4A
DVI 2B DVI 3B DVI 4B
DVI 1A
DVI 1B
Resolution： 1920×1080 60.00Hz
Here is the instruction of the above:
Instruction
Input 1 1920×1080
Input 1 and current input signal resolution, the right
side is the 3 input sources corresponding to input 1.
For the vertical bar on the left side of each signal
source, green indicates have signal, red indicates no
signal.
The font color of each source is divided into yellow
and white: yellow means that the signal is set as the
input, and white means that this signal is not set as
the input (this also applies to Input 2, Input 3, Input
4, Input 5, Input 6 right side display content).
Input 2 1920×1080
Input 2 and current input signal resolution, and the
right side is the 3 input sources of Input 2.
Input 3 No Signal
Input 3 and current input signal resolution, and the
right side is the 3 input sources of Input 3.