26
Control unit MGC
Description "mSwing Connect" programme
4.5
"Service" tab
Use the "Service" tab to select the target stop and set the 3 target positions
"Closed (0°)", "Left" and " Right".
The target stop is the stop that is approached during homing. The target stop
should correspond to the "Open" position.
In the case of homing, the blocking element is first moved to the "Open"
position and then to the "Closed" position (home position).
Fig. 10: "Service" tab – "Information" field
4.5.1
Selecting target stop and setting target positions
Prerequisite
›
The mechanical end stops are set. The mechanical end stops must be set at
least 3° behind the respective target position. If, for example, the target
stop for the right is to be 90°, the mechanical end stop must be set to at
least 93°.
›
After setting the mechanical end stops, a reset and thus a homing was
performed.
Reset:
IMPORTANT!
For setting the mechanical end stops, see separate operating
instructions "Swing door mSwing MHTM™
FlowMotion® (Doc.ID: 5817,0032)".