Magnetic MGCplus, Manual, Page: 67 / 84

67
Control unit MGCplus
Corrective action
7.3.1 Event, warning and error messages – Logic control (Control unit)
"[nn]" is a placeholder for the number of the component that may be causing
an error.
Number Designation Possible cause Corrective action
ERROR
0x10001000 Hardware revision could
not be detected
MPM01 extension mod-
ule defective
›
Contact service.
ERROR
0x11001000 SD card error MPM01 extension mod-
ule defective
›
Contact service.
ERROR
0x20001000 CANopen system bus
could not be started
A defective IO extension
or motor control is con-
nected to the system
bus.
›
Check the CAN bus wiring.
›
Check the settings of the
terminating resistance.
ERROR
0x30013003
0x30023004 Motor for wing no. 1 / 2
not available
Incorrect motor address
setting or defective mo-
tor electronics
›
Check for correct motor
address setting.
›
Check the CAN bus wiring.
›
Check the settings of the
terminating resistance.
›
Contact service.
ERROR
0x3001F003
0x3002F004 Information on motor
no. 1 / 2 could not be
read
CAN system bus faulty
›
Check the CAN bus wiring.
›
Check the settings of the
terminating resistance.
›
Contact service.
ERROR
0x30011003
0x30021004 Internal referencing er-
ror on motor for wing
no. 1 / 2
Gear installed in motor
defective
›
Change motor unit.
ERROR
0x3001F100
0x3002F100 Wrong motor type for
wing no. 1 / 2
Wrong motor type used
›
Change motor unit.
ERROR
0x4001F000
0x4002F000 The minimum required
span of wing 1 / 2 was
not reached during
homing
Wing 1 / 2 locked during
commissioning or wing
mechanics defective
›
Remove obstacles that
block the movement of
the wing during commis-
sioning.
›
Switch off the pedestrian
gate and check the wing
for ease of movement.