Magnetic MGCplus, Manual, Page: 33 / 84

33
Control unit MGCplus
Parameterising control unit
5.2 Entering password
You need to enter a password in the following cases:
›
You would like to change parameters in the control unit and the password
protection was activated.
›
You would like to reset the parameters to factory settings.
If a password is required, the following view is displayed:
Mag008
18
– – –
0
Password
Fig. 12: View "Enter password"
1. Use the two middle buttons « », « » to enter the first digit of the
password.
2. Use the right button « » to select the second digit of the password. The
following view is displayed:
Mag008
28
– –
*
0
Password
Fig. 13: View "Enter second digit of the password"
3. Use the two middle buttons « », « » to enter the second digit of the
password.
4. Use the right button « » to select the third digit of the password.
5. Use the two middle buttons «
», « » to enter the third digit of the
password.