Pedestrian Pivot Barrier
MPP-112 / MPP-122 / MPP-132 / MPP-212 / MPP-222
Configuration of pedestrian barrier
5817,0016EN / Version 00
51
9.2 Configuring the pedestrian barrier
The control unit MBC was specifically developed by MAGNETIC
for use in own products. Control of the pedestrian pivot barrier
MPP is only possible using the MAGNETIC servo controller MMC-
120.
Motor (MHTM) and sensor are directly wired to the MMC. The
connection between the MMC and MBC is established by CAN
BUS. Also see electrical circuit diagram.
Some functions and parameters of the pedestrian barrier can be
adjusted with the 8 DIP switches.
The connection side on the customer's site comprises:
3 DIP switch blocks: DIP S1, DIP S2 and DIP S3
See following figure.
7-segment display
6 green LEDs for outputs
7 red LEDs for inputs
3 pluggable coded terminal strips for connection of in- and
outputs
NOTE!
Changes to DIP switch settings only become
effective after the power supply to the pedestrian
barrier has been switched off and then on again.
Fig. 19: DIP switch block S1, S2 and S3
1
DIP switch block S1
2
DIP switch block S2
3
DIP switch block S3
