Magnetic Autocontrol MHTM, Operating Instructions Manual

Page: 12 / 132

Barrier MHTM
TM
MicroDrive Access and Parking
Safety
12 5815,5001EN / Version 05
2 Safety
2.1 Intended use of the barriers
The MAGNETIC MHTM
TM
MicroDrive barriers are exclusively
intended for controlling access to and exit of certain road vehicles
in or from certain areas.
The barrier is either controlled by a person in manual operating
modes or by access control systems in automatic operating modes
and monitored by induction loops and/or safety light barriers.
Electrical energy is used exclusively for operating the barrier. The
barrier boom weight is balanced out by spring energy.
The barrier consists of a barrier housing with drive system and
control, as well as the barrier boom.
2.1.1 Intended use for certain road vehicles
Certain road vehicles according to chapter 2.1 paragraph 1 need to
have sufficiently large metal areas in the vehicle floor area to
enable detection by induction loops.
Other or complementary safety facilities must be provided for road
vehicles that cannot be detected by induction looks due to the
metal area in the vehicle floor area being too small.
Additional safety installations must be provided for motorcycles.
→
Also see page 44, arrangement of "passenger car and motor-
cycle loops".
2.1.2 Barrier, pedestrian traffic impossible
In vehicle barriers where personal traffic is excluded and use by
pedestrians is not intended.
The presence of persons and animals must be excluded by the
operator. This shall apply for the following barrier types:
 ACCESS PRO
 PARKING, PARKING PRO