Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 72 / 196

Barrier MHTM
TM
MicroDrive
Assembly and installation
72 5815,5001US / Version 02.66
The edge protection is included in the delivery loosely in 6.56 ft
(2 m) pieces. If the barrier was ordered with the light strips option,
the barrier arm is delivered with the mounted edge protection.
The number of edge protections is according to the length of the
long barrier arm profile.
1. Measure the length of the long barrier arm profile.
2. Shorten edge protection to the required length with a saw.
When the length of the barrier arm profile is, for example,
11.5 ft (3.5 m), saw off one edge protection to 4.92 ft (1.5 m).
3. Moisten lower half of the barrier arm onto which the edge
protection is pushed with water.
4. Slide edge protection in the barrier arm groove.
5. Slide further edge protections into the intended groove until
the edge protection ends flush with the barrier arm.
8.11 Assembling flange and barrier arm
Danger of injury
CAUTION!
CAUTION!
Danger of injury!
There is a danger of injury when mounting the
barrier arm.
Therefore:
– Barrier arms as of a length of 14.8 ft (4.5 m)
must be installed by two persons. We
recommend also installing shorter barrier arms
with two persons.
8.11.1 Type "VarioBoom" and "MicroBoom"
Do not grease
NOTICE!
NOTICE!
Improper lubrication of components, in
particular the counter bearing or flange shaft,
may lead to damage of the equipment!
Therefore:
– Do not grease the counter bearing and flange
shaft.
1. Secure barrier danger area e.g. with barrier tape.
2. Remove the barrier housing hood.
3. Remove the barrier housing door.