Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 71 / 196

Barrier MHTM
TM
MicroDrive
Assembly and installation
5815,5001US / Version 02.66 71
8.9 Assemble barrier arm type "VarioBoom"
The barrier arm type "VarioBoom" is delivered in two parts.
 Short barrier arm profile with assembled connection plates, half-
shells and end caps.
 Long barrier arm profile
The mounting material is included in delivery.
1. Remove transport rubber bands.
2. Disassemble the two half-shells from the short barrier arm
profile.
3. Slide long barrier arm profile over the two connection plates.
4. Attach long barrier arm profile to both connection plates with
the 4 Torx. The larger bores must remain free.
5. Attach the two half-shells with the washers and the hexagon
socket screws.
8.10 Assemble edge protection
Missing edge protection at
the barrier arm
WARNING!
WARNING!
Danger from missing edge protection at the
barrier arm!
Missing edge protection at the barrier arm may
cause severe or lethal injury for persons, bicyclers
and cabriolet drivers when the barrier arm closes!
Therefore:
– Assemble edge protection.
– If the edge protection is damaged, it must be
replaced immediately.
NOTE!
If you use a pendulum support, observe that you
must mount part of the edge protection in front of
the pendulum support and part of the edge
protection behind the pendulum support.