1161306-0
29
3.4 Probe connection: temperature and rpm
The ports where to connect the
probes (option) are placed on the
instrument rear side.
In particular, the D-sub connector
marked with the symbol “°C” shall be
used to connect the temperature
probe, whereas the "RPM" marked
one for connecting the rev counter
with pliers or the M.C.T.C.NET one of
the rs232 type.
4 Gas analyzer use
Upon analyzer Smart Gas switch on the display will show a short introduction
message, then the analyzer enters automatically in the main page where it is
possible to select the type of test to be carried out.
<Gas analysis>
►Free page
Light Test
Official proc.
From the main selection page it is possible to gain access to the:
-
Free page: to read the exhaust and engine principal values (engine
temperature and rpm).
-
Mandatory emission test: for the fuel vehicles mandatory emission test.
-
Official procedure: to carry out the test in accordance with the most
recent Standards in matter of gas analysis.