Parameters
37
Parameters
Parameter Introduction
This section describes the parameter menu
structure; how to navigate this menu structure
via the HPV 900 Series 2 digital operator; and
a detailed description of each parameter.
Parameters are grouped under six major
menus:
ADJUST A0
CONFIGURE C0
UTILITY U0
FAULTS F0
DISPLAY 1 D0
DISPLAY 2 D0
When the SUB-MENU LED is
not
lit, the
currently selected menu is shown on the top
line of the Digital Operator display and the
currently selected sub-menu is shown on the
bottom line of the Digital Operator display.
The menu/sub-menu tree is shown below.
The digital operator keys operate on three
levels, the menu level, the sub-menu level and
the entry level. At the menu level, they
function to navigate between menus or sub-
menus. At the sub-menu level, they navigate
between sub-menus or menu items. At the
entry level, they are used to adjust values or
select options. Six (6) keys are used for this
navigation, they are:
Figure 31: Digital Operator Keys
Display 1 D0
Adjust A0
Configure C0
Utility U0
Faults F0
Display 2 D0
Elevator
Data D1
Power Data
D2
Drive A1
S-Curves
A2
Multistep
Ref A3
Power
Convert A4
Motor A5
User Switches
C1
Logic Inputs
C2
Logic Outputs
C3
Analog
Outputs C4
Password U1
Hidden Items U2
Units U3
Ovrspeed Test U4
Restore Dflts U5
Drive Info U6
Hex Monitor U7
Language Sel U8
Basics U9
Alignment U10
Time U11
AutoTune U12
UPLOAD/DL U13
Power Meter U14
OVERLOAD
TEST U15
Active
Faults F1
Fault
History F2
Sorted
History F3
Reset
Faults F4
Elevator Data
D1
Power Data
D2
Figure 32: Menu/Sub-Menu Tree
8:55 May 20
A0 ADJUST
A1 DRIVE
READY
RUN
USER
FAULT
TORQUE
LIMIT
SUB MENU
DATA ENTRY
READY
RUN
USER
FAULT
TORQUE
LIMIT
ENTER
ESC
SUB
MENU
DATA ENTRY
Up Arrow Key
Right Arrow Key
Left Arrow Key
ESCAPE Key
Down Arrow Key
ENTER Key
