Magnetar UDP800, User Manual

Page: 49 / 60

Other data
44
Other Data
Reminders
⚫ T o prolong service life of the player, you’d better not power the player on again until at least 30 seconds after
the player is powered off.
⚫ After use, please take the compact disc out and power the player off.
⚫ In playing some compact discs, certain functions of the player would be unavailable.
⚫ The player would not fully support tidbits of certain compact discs, but this is not a fault of the player.
⚫ If the player malfunctions, please power the player off, and don ’t power it on again until 30 seconds later.
Troubleshooting
You can choose general operation problems as shown in the table here below.
Faults Potential Causes Solutions Remarks
No sound
The audio cable is incorrectly
connected
Inspect the audio cable and please reconnect the cable when
necessary
Mute mode is turned on Press MUTE to cancel the mute mode
Volume is too low Press to raise volume to 100
When SACD is played, the
audios connected are coaxial
or optical and digital
This connection mode is not supported for the time being due to
copyright limits of SACD. Please choose analog or HDMI audio
output. Or you can set SACD priority as CD mode so that the
player will play the CD layer.
In playing DVD-Audio, the
audios connected are coaxial
or optical and digital
This connection mode is not supported for the time being due to
copyright limits of DVD-Audio. Please choose analog or HDMI
audio output. Or you can switch to the DVD-Video playing mode.
No image
The video cable is incorrectly
connected
Inspect the video cable and reconnect it when necessary
TV input source is
incorrectly chosen
Choose player input
U nder the “pure tone” mode Press PURE TONE to cancel this mode
T V sets don’t support this
video output format
Choose output resolution suitable for your TV set
No color Saturation setting is too low Check saturation settings of your TV set and player
Color is wrong Color space is incorrectly set
To output videos through HDMI, please check color space
settings of your TV set and player
“No compact
disc” or “unknown
disc” error
The player contains no
compact disc or the compact
disc is incompatible
Take the compact disc out for inspection
The recording side of the disc is Take the disc out and clear the dirt/stain or fingerprint off the disc.