Magnescale LY71, Simplified Manual

Page: 51 / 146

LY71
(E)
17
5. Key Operations
Reset key and external reset input At power ON display
→
Count display: During restart
operation, INC display
(master calibration OFF) or when
master calibration is ON, display
waits to go past reference point.
After going past reference point,
display changes to count display.
During count Count display Each axis : INC = 0, ABS = unchanged,
display axis Peak value = 0
Error display axis Each axis : INC = 0, ABS = 0, Peak value = 0
However, when master calibration is
ON, display waits to go past reference
point.
Start key and external start input At power ON Operation prohibited
During count Count display Restarts peak value calculation for each axis/all
display axis axes.
Error display axis Operation prohibited
ABS/INC display switching key At power ON Operation prohibited
During count Count display Switches each axis/all axes between ABS and INC
display axis display.
Error display axis Operation prohibited
SETUP key At power ON Hold down to access basic settings.
During count display Accesses advanced settings.
Preset key At power ON Operation prohibited
During count display Preset lamp lights on and preset operation is
enabled (= preset mode).
Axis select key, numeric key and Valid in preset mode (Prohibited when datum point lamp or REF lamp is
ENT key/ key operation lit.)
During count Count display Up to three values can be stored/edited for each
display axis axis.
Error display axis Operation prohibited
External preset value call Valid even in other than preset (Prohibited when datum point lamp or REF lamp is
(preset recall input) mode lit.)
During count Count display Calls the first preset value for each axis.
display axis
Error display axis Operation prohibited
Datum When not using master At power ON Version display
point calibration function
During count display Datum point lamp lights on and datum point
key
operation is enabled (= datum point mode).
Axis select key, numeric key and Valid in datum point mode (Prohibited when preset lamp or REF lamp is lit.)
ENT key operation
During count Count display The values for each axis can be stored/edited.
display axis
Error display axis Operation prohibited
Datum When using master At power ON Version display
point calibration function
During count display Datum point lamp lights on and master setting
key
operation is enabled (= master setting mode).
Axis select key, numeric key and Valid in master setting mode (Prohibited when preset lamp or REF lamp is lit.)
ENT key operation
During count Count display The values for each axis can be stored/edited.
display axis
Error display axis Operation prohibited