CARE AND MAINTENANCE
CARE AND MAINTENANCE
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
customer service or the manufacturer.
IMPORTANT:
1. Air filter
- Clean the air filter at least once every two weeks to prevent
degrading fan operation because of dust.
- Removal
This unit has two filters. Grasp the upper filter tab(Fig.25),
,,
,,
pull the filter out then up . Remove the lower filter by
loosening the screw, taking down the air inlet grille, then
removing the air filter as shown in Fig.26 & 27.
- Cleaning
Wash the air filter by immersing it gently in warm water
with a neutral detergent. Rinse the filter and dry in a
shady place.
- Mounting
Reinsert the upper air filter from the top after cleaning, attach
the lower air filter on the air inlet grille, then install the grille
by using the screw.
2. Unit enclosure
- Use a lint-free cloth soaked in neutral detergent to clean
the unit enclosure. Finish with a dry clean cloth.
3. Unit idle for a long time
,,
,,
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet
. Place the open end of the hose
directly over a drain or separate container to dispose of
later (See Fig.22 & 23).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray should drain out (See Fig.24).
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape(Fig.28). Remove the batteries from
the remote controller.
- Clean the air filter and reinstall it.
- Unscrew the exhaust hose to the right or left and pull out
to detach(Fig.29), keep it safety, and cover the window
(wall) hole with the adaptor cap.
Fig.29
14
Fig.25
Air filter
(slide out)
Fig.26
Fig.28
Remove three
screws and
take the air
intake grille
down
Remove the air filter
out from the grille
Fig.27
Band
Power
cord
