OPERATING & MAINTENANCE INSTRUCTION MANUAL
MODELS 427A (R-1), 428A (R-2), AND 429A (R-3) WELD HEADS
REV. AB
MODEL 514 TUBEMASTER OR 515/516 PIPEMASTER POWER SUPPLY
4
THESE DOCUMENTS, AND THE CONTAINED INFORMATION HEREIN, ARE PROPRIETARY AND ARE NOT TO BE REPRODUCED, USED OR DISCLOSED TO
OTHERS FOR MANUFACTURE OR FOR ANY OTHER PURPOSE, EXCEPT AS SPECIFICALLY AUTHORIZED, IN WRITING, BY MAGNATECH, LLC
3.0
REFERENCE DOCUMENTS
Referenced standards and regulations may be purchased from the originating organization (AWS, ANSI,
NFPA, etc.). See also
Principle Safety Standards
for ordering information.
3.1
Standards
AWS F3.M/F3.2
Ventilation Guide for Weld Fume
ANSI Z49.1
Safety in Welding, Cutting, and Allied Processes
ANSI/ISEA Z87.1
American National Standard for Occupational and Educational Personal Eye
and Face Protection Devices
ASTM F2412
Standard Test Methods for Foot Protection
ASTM A106/A106M
Standard Specification for Seamless Carbon Steel Pipe for High-Temperature
Service
AWS F4.1
Safe Practices for The Preparation Of Containers and Piping for Welding and
Cutting
OSHA Standard 29 CFR, Part
1910, Subpart Q
Welding, Cutting And Brazing
NFPA 51
Standard for Fire Prevention During Welding, Cutting, and Other Hot Work
NFPA 70
National Electrical Code
CGA P-1
Safe Handling of Compressed Gases in Cylinders
CSA W117.2
Safety in Welding, Cutting and Allied Processes
Miller 215 994
Guidelines for Gas Tungsten Arc Welding (GTAW)
DHHS (NIOSH)
Publication No. 94-110
Applications Manual for the Revised NIOSH Lifting Equation
3.2
Regulations (Repairs and Maintenance)
Any repairs to the Controller or power source are only to be made by the factory, or a licensed electrician.
In the course of any service, the following regulations must be observed (as a minimum):
ANSI/IEC 60974-1
Arc Welding Equipment – Part 1: Welding Power Sources
VBG 4, 5
National Regulations for Safety and Accident Prevention
VBG 15, 33/49
Welding, Cutting and Allied Processes
VDE 0701-1
Repair, Modification and Inspection of Electrical Appliances; General
Requirements
VDE 0702-1
Repeat Tests on Electrical Appliances