BLUEPIRAT2 | USER MANUAL/
page 26 of 82
7.2
Terminal IP address
Each
BLUEPIRAT
has an additional, permanently set network address internally, which can be
used to reach the device if the set IP address cannot be reached. This address can also be
used if several devices have the same IP setting. For this feature every data logger has a sec-
ond, fixed IP address in the subnet 10.1.X.Y which can be contacted by the System Client.
Each terminal IP address is unique!
These additional IP addresses are all located in subnet 10.1.X.Y. The system client can access
the devices via this IP address
Attention:
To use this option your computers network port has to be set to the fixed IP address
10.1.255.254 and subnet mask 255.255.0.0.
To set this IP address, please go to the specific network connection at
[Properties]
change the
IP settings and close the window with
[OK]
.
Figure 7.5: Change IP settings
If this is given, the system client finds the devices on the alternative IP address and displays
them in the network logger list with the terminal IP address. From then on the devices can be
used as usual. This allows the loggers to be read out simultaneously without having to operate
them as a DHCP client or change the IP settings on each logger.
