BLUEPIRAT2 | USER MANUAL/
page 23 of 82
6.7.4.7 Install configuration
On the external memory device a folder with the name configuration has to be created,
in which only one configuration file has to be stored.
There are two ways to update the firmware of the logger with a removable device.
1) Over the device menu
a) In the System Client under General / External Storage: Set [Configuration via Remova-
ble Media (CF/SD/USB):] to [Selection by user via device menu]
b) After pressing the [menu] knob a verification message will be displayed. With the [OFF /
ESC] button the process can be aborted. With the [menu] knob the BLUEPIRAT2 begins
to install the configuration. If the installation was successful, the message <Config up-
dated> will be displayed. Otherwise the message <install failed of Config file> is shown.
2) Automatically when plugged in or on startup
a) In the System Client under General / External Storage: Set [Configuration via Remova-
ble Media (CF/SD/USB):] to [Automatic detection on startup / plugin].
b) After inserting the removable device or after logger startup with plugged removable de-
vice the configuration will be installed automatically. If the installation was successful,
the message <Config updated> will be displayed. Otherwise the message <install failed
of Config file> is shown.
6.7.4.8 Safely remove ext. Mem.
If you want to remove the external memory device, you have to select this sub category and
press the
[menu]
knob. After that the message <Mem. Device clear to remove now> appears in
the display and you can safely remove the external memory device from the data logger.
