BLUEPIRAT2 | USER MANUAL/
page 16 of 82
On the front side of the BLUEPIRAT2 you will find the display and some control elements.
The BLUEPIRAT2 is available with one 1-Gbit-Ethernet port on the front and also with four addi-
tional 100-Mbit-Ethernet ports, where an Ethernet switch is integrated. A mini switch is available
with 4 RJ45 connectors.
6.1
ON / Trigger button
The
[ON / Trigger]
button is used to switch on the BLUEPIRAT2 if the data logger is connected
to the power and currently in sleep mode.
During operation, interesting points in time can be designated by the
[ON / Trigger]
button.
When pressing this button, the data logger saves the current time to hard drive. It is possible to
configure the data logger to send a CAN message as an acknowledgement of setting a marker.
Additionally, it is possible to define a message that triggers a marker. In all cases, triggers are
debounced, allowing only up to ten triggers in between every two seconds.
When downloading the data, the client displays all markers in an event overview. In this event
overview, the client can be configured to transfer the data around the selected markers.
6.1.1 Resetting the network settings
Important notice:
Due to a wrong network setting it might be impossible to reach the data logger any more.
In this case the network configuration can be resetted by a long press on the [ON / Trig-
ger] button for ca. 5
– 10 sec. to default settings: DHCP server with IP:192.168.0.233.
Afterwards the data logger can be reached again by using a direct connection with a
PC/Laptop.
6.2
OFF / Esc button
If the BLUEPIRAT2 is operating and you hold the
[OFF / Esc]
button for longer time, the data
logger will go into the standby mode.
If you only push the
[OFF / Esc]
button for short time you leave the current menu state.
