BLUEPIRAT SERIES | CAMERA USER GUIDE/
page 24 of 93
Figure 5.30 Firmware rollback
5.6
Reset to factory settings
In addition to the procedure described above, you can also reset the Main Unit to the factory
settings as follows:
1. Disconnect power from the product.
2. Hold down the control button between the two SD card slots on the right side
and
3. Reconnect the power supply.
4. Keep the control button pressed for 15
–30 seconds until the status LED indicator flashes
amber.
5. Release the control button.
6. The process is complete when the status LED indicator turns green. The product has
been reset to the factory default settings.
