Magma
EB3600-P | Chapter 6 Rack Slide Installation
91
The screws that come with the slides will be too long and could potentially touch the Host
PCB’s. If you reuse the screws that are already on the sides, you will be fine. These screws have
Sems Lock washers and get 2 full turns into the threads and there are several that can be used
on any rack slides. They do not protrude deep into the chassis, but they give enough support.
Assemble Slide Rails (STEP 3)
Measure the rack from front to back so you can confirm how long the rail must be to fit properly.
Next, assemble Slide piece
B
with end bracket
D
as shown below and secure with 2 Panhead screws and
locking nut. Ensure the Phillips screw head is located on the “open” side of the Slide pieces as shown
below. Tighten finger tight only to allow for minor adjustment during assembly in the
Step 5.
Summary of Contents for ExpressBox EB3600-P
