![Magio MG-962 Instruction Manual Download Page 36](http://html.mh-extra.com/html/magio/mg-962/mg-962_instruction-manual_691056036.webp)
36
EN
« » position, steam will come out from the steam wand. Froth milk
in the way moving vessel round from up to down. When the required
purpose is reached, you can turn the knob to the « » position.
4. Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
5. Pour the frothed milk into the espresso prepared, now the cappuccino
is ready. Sweeten to taste and if desired, sprinkle the froth with a little
cocoa powder.
6. Press the power switch to cut off the power source.
During operation, if the coffee and steam indicator lights up at the same
time, you can not make coffee, if you want to make coffee, repeat above
steps.
The steam wand (without the frothing device) can be used to make hot
beverages like drinking chocolate, and water.
Methods:
1. Remove the detachable tank and fill it with desired water, the water
level should not exceed the “MAX” mark in the tank.
2. Then place the tank into the appliance properly.
3. Then connecting the appliance to the power supply source. Press the
ON/OFF switch, the power indicator (red) is illuminated.
4. Turn the knob to the «
» position, make sure the steam button is
on the higher position which is the « » position, the pump will pump
water, when there is water flowing out, close the pump immediately,
pressing down the steam button to the lower position which is the « »
position and waiting for a moment, the appliance begins to be heated
until the steam indicator is illuminated, it shows the heating is finished.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the knob to the
« » position. When the required temperature is reached, you can
turn the knob to the « » position. Press the power switch to cut off
the power source.
1. If during the filter cleaning you find out that the openings are blocked
with ground coffee remnants, you can clean them with a small brush.
2. Clean the coffee maker body with a soft damp cloth, and then wipe
the unit body dry. Do not use metal brushes or abrasives.
If you want to make coffee again after frothing milk. You should turn
the knob to the « » position and press the steam button to the
higher position which is the « » position, the pump will pump water
until the coffee indicator turns off, then turn the knob to the « »
position and wait until the coffee indicator lights up again.
Note
Producing steam to heat liquids
Cleaning and maintenance