LUCKY NUMBERS -
USER’S MANUAL
www.magicplay.eu
7
4. IMPORTANT INFORMATION AND GAMEPLAY
IMPORTANT!
DEVICE SOFTWARE IS COPYRIGHT PROTECTED. COPYING AND DISTRIBUTION IS
STRICTLY PROHIBITED. IT IS ALSO FORBIDDEN TO INTERFERE IN THE INTEGRITY OF
SOFTWARE THROUGH MODIFICATION OR IMPLEMENTATION OF ANY CHANGES
WITHOUT APPROVAL OF THE MANUFACTURER. ANY ATTEMPTS OF SOFTWARE
CHANGES, OTHER THAN THOSE SPECIFIED BY THE MANUFACTURER MAY RESULT IN
WARRANTY LOSS.
4.1. SD CARD
The SD card contains audio sample files in MP3 format. There is one sound sample or each prize, and then
some for pause, play and active (flash). Preferably, the MP3
’
s should have a sample rate of 144kbps to
192kbps, but other rates may also function. If any of these files is missing at power-up, the display will
show an error message.
Do NOT change the SD-card under power. Switch off first!
To access the micro-SD card, slide the silver cover approximately 1mm upwards until it hinges open. Install
the micro-SD card exactly into the slots, keep it depressed there, then close the cover and slide it down.
The micro-SD card must be formatted as FAT32, the most common format for these cards. FAT12, FAT16,
NTFS, ExFAT and other formats are not supported. If necessary, reformat the disk on a Windows PC with a
micro-SD slot or USB-interface, and force the PC to use FAT32 or use a special tool, e.g. from:
https://www.sdcard.org/downloads/formatter_4/
Cards with a capacity of 1 to 16GB (a.o. Lexar and Sandisk) have been successfully tested in the machine,
and larger capacities should work as well. Note however that there may be cards for sale that do not work
in embedded systems. It is strongly advised to first test a card before ordering a larger batch.
