
Page 25
STOP!
Unauthorized
modifications
void
your
warranty,
constitute
remanufacturing and may render your chair unsafe.
10 Fault finding
During fault conditions the chair either will not drive or drives very slowly.
10.1 Limp Mode
If the DX system detects a fault that does not demand the wheelchair be stopped completely; it
will go into ‘Limp Mode’. This enables the wheelchair to be driven to a safe place at a reduced
speed.
10.2 Stuck Power Button
If the power button is pushed and not released; the system switches off. To unlock the system,
press the on/off button and then press the horn button twice within 10 seconds (Section 6.5.3)
10.3 Joystick out of neutral at power up
If the joystick is not in the center position when the system is switched on; the wheelchair will
not drive. This is to prevent inadvertent movement. If the joystick is returned to the center within
4 seconds the chair will then drive normally. If the joystick is not returned to center within 4
seconds, the DX2 system must be switched off and then on again.
10.4 Battery Warning Conditions
Check the batteries are charges. If the charge icon is red, put the chair on charge immediately
Note if the batteries are allowed to discharge completely, they may not recharge (see section 7)
in the event of this happening please contact your Magic Mobility Dealer for assistance.
10.5 Fault Codes
In the case of a fault; the DX2 controller may display a flash
code like the one pictured. The number indicates where the
problem is in the system. The following information may help
diagnose some faults
1
Turn the DX system off the back on again
Check the lead to the joystick module – has it been damaged or dislodged
If the above do not clear the fault, please contact your Magic Mobility dealer
2
This may not be a fault. If you have a seat elevator, the wheelchair is programmed
to drive slowly when the seat is elevated. The flash code is indicating that the
chair’s driving speed has been reduced while elevated.
Ensure the seat is in its lowest position before driving
If the above do not clear the fault, please contact your Magic Mobility dealer
Summary of Contents for Extreme X8
Page 1: ...Page 1 Owners Manual...