Page 31
Appendix A - ANSI/RESNA WC/Vol 1
– Section 19 and
ISO7176-19 restraint system; if fitted.
The wheelchair is not provided with a wheelchair anchored belt restraint as standard. It must be
requested at the time of ordering the wheelchair or it can be retrofitted later on by a Magic
Mobility Representative.
Once fitted; the wheelchair complies with the requirements of RESNA WC-4, Section 19 and
ISO7176-19.
It is recommended that people who use wheelchairs should transfer to the vehicle seat and use
the vehicle-installed occupant restraint system when this is feasible.
When seat positioning options are fitted the following should be followed unless necessary for
postural or medical requirements of the occupant.
Seat elevator
: fully DOWN i.e. the seat at its lowest
Seat Tilt
: Fully DOWN i.e. the seat parallel to the ground
Legrest
: Fully DOWN i.e. feet close to the floor, knees bent at 90°
Backrest
: Upright i.e. at or close to 90° to the seat
Figure 9 - X8 Tie Down Locations
There are four wheelchair securement points on an X8; two at the front and two at the rear.
Rear Tie Down
Front Tie Down
Front Tie Down
Rear Tie Down
Pelvic Belt
attachment
point
Pelvic Belt
attachment
point
