Magellan MobileMapper CX - Hiking GPS Receiver, Getting Started Manual

Page: 49 / 86

English
41
- Tap
OK
to close the DGPS Configuration window. The fol-
lowing two messages are displayed successively: “
Please
wait...
” and “
Processing incoming data packets...
”.
- Tap
OK
to close the message window.
- Run GPS Status (see Viewing Current GPS Status on
page 15 ) and check that MobileMapper CX is now operat-
ing in DGPS mode.
- Start your application.
Returning to Autonomous GPS Mode
- Tap on , then
Programs>GPS Utilities>DGPS Configuration
.
- Tap on the
Select Mode
button.
- In the Select Differential Mode window, enable the
None
option.
- Tap
OK
to close the window. This takes you back to the
DGPS Configuration window where you can read the
choice you have just made.
- Tap
OK
again. The window is closed and MobileMapper CX
starts operating instantly in Autonomous GPS mode.
Subsequent Uses
Next time you turn on MobileMapper CX and you run the
DGPS Configuration utility, you will be prompted to run the
same DGPS mode as the one you last used. If it was Direct IP
or NTRIP, the configuration you last used is preset. If it was
MobileMapper Beacon, the last used station is preset.
This means the only thing you will have to do to get the Mo-
bileMapper CX running, and provided you agree with all the
default choices, is to tap on the
Connect
button and then start
using the corrections received by tapping
OK
.
CAUTION! For Direct IP or NTRIP, you will have to re-establish
the GPRS connection via Bluetooth (see Subsequent Uses on
page 27 ) before running the DGPS Configuration utility. For
MobileMapper Beacon via Bluetooth, you will have to re-es-
tablish the Bluetooth link before running the DGPS configura-
tion utility.