Magellan MobileMapper CX - Hiking GPS Receiver, Getting Started Manual

Page: 44 / 86

English
36
- Select
New
selected in the
Direct IP Configuration
field, tap
on the
Add
button and then enter the following parame-
ters:
•
Name
: Direct IP Configuration Name (freely choose a
name)
•
Host
: IP address
•
Port
: Port number
(The last two parameters should have been passed on
to you by the correction provider.)
- Tap
OK
. The name of the configuration you have just cre-
ated is now pre-selected in the
Direct IP Configuration
field.
Two new buttons (
Edit
and
Delete
) are shown under this
field allowing you to respectively edit or delete this config-
uration. When you edit an existing configuration, note that
you cannot change its name.
To create a second Direct IP configuration, you would tap
the down arrow to the right of the
Direct IP Configuration
field and select
New
. The
Add
button would appear again
under the field. You would then tap this button, enter the
three parameters of the second configuration and tap
OK
to save this new configuration.
- After selecting the desired configuration from the
Direct IP
Configuration
field, tap
OK
. This takes you back to the
DGPS Configuration window. On top of the screen, you can
read part of the settings you have just made.
- Tap the
Connect
button. The DGPS Configuration screen
now indicates the amount of incoming data packets (bot-
tom of the screen) as well as the status of the DGPS mode
(top of the screen).
- Tap
OK
to close the DGPS Configuration window. The fol-
lowing two messages are displayed successively: “
Please
wait...
” and “
Processing incoming data packets...
”.
- Tap
OK
to close the message window.
- Run GPS Status (see Viewing Current GPS Status on
page 15 ) and check that MobileMapper CX is now operat-
ing in DGPS mode.
- Start your application.