59
12-VOLT BATTERY
12-VOLT BATTERY
Only install a 12-volt battery of the same type
and rating.
Make sure the ignition key is in the
OFF
position before the 12-volt
battery is disconnected.
Always disconnect the negative terminal on
the 12-volt battery first and reconnect the
negative terminal last.
When removing and installing a 12-volt
battery, make sure that the
battery terminals do not come into
contact with any metal objects or vehicle
components.
12-volt battery access panel
Remove the primary and secondary
batteries. For further information, see
Removing the primary battery on page 29
and Removing the secondary battery on
page 31.
The 12-volt battery can be accessed by
removing the battery access panel.
To remove the battery access panel:
1. Make sure the ignition key is in the
OFF
position.
2. Remove the 2 screws securing the
Maeving badge to the battery access
panel and remove the badge.
Note
: When refitting, tighten to
2 Nm
.
3. Remove the 3 bolts securing the access
panel to the electronics housing and
remove the panel.
Note
: When refitting, tighten to
8 Nm
.
Note
: The installation procedure is
the reverse of removal.
!
!
!
!
!
!
!
!
!
3
2
Summary of Contents for RM1
Page 1: ......
Page 76: ...Maeving RM1 Owner s Handbook 76 SERVICE AND MAINTENANCE General repair notes...
Page 83: ......
Page 84: ......