MAESTRO WIRELESS SOLUTIONS
| Services
208
E-SERIES | USER MANUAL VERSION 2.0.1
http://support.maestro-wireless.com
OpenVPN
Services > OpenVPN
Open VPN is an open-source software application that implements virtual private
network (VPN) techniques for creating secure point-to-point or site-to-site
connections. It uses the Open SSL library to provide encryption of both the data
and control channels. Open VPN can run over User Datagram Protocol (UDP)
or Transmission Control Protocol (TCP) transports, multiplexing created SSL tunnels
on a single TCP/UDP port. Open VPN fully supports IPv6 as protocol of the virtual
network inside a tunnel and the Open VPN applications can also establish
connections via IPv6. It has the ability to work through most proxy
servers (including HTTP) and is good at working through Network address
translation (NAT) and getting out through firewalls. The server configuration has
the ability to "push" certain network configuration options to the clients. These
include IP addresses, routing commands, and a few connection options.
E200 series supports Open VPN client, Server and Pass Through.
a.
Open VPN Client
You can access the Open VPN client in Services / Open VPN.
Open VPN Client will attach itself to the configured Open VPN server over any
available WAN interface. If the auto-connect function is enables, Open VPN will not
only connect over available WAN but also switch between WANs as and when one
WAN fails-over to another and also auto starts in every reboot. This can be
achieved by clicking on the enabled tick box.
You can either edit the sample client or create your own configuration from ground
up.
Note
Only OpenVPN client is supported.
You must manually enter the DNS from
