MADRIX LUNA 4, User Manual

Page: 14 / 115

[Part 2] Device Configuration
//14
www.madrix.com
MADRIX LUNA User Manual
Device Name You can change the description of the device by entering a name.
[This refers to the Long Name of Art-Net.]
Confirm with Set
Device Settings You can change the basic network device settings.
Confirm with Set
§
IP Address
§
Subnet Mask
[Please note: Your devices and the sender, such as the PC that runs MADRIX 5,
need to have the same subnet mask!]
DMX Output Settings This section shows the settings for the DMX output ports [DMX 1 - 4/8/16].
Confirm with Set
Network Universe - Assigns the universe to the particular output port.
§
By default, universe 1 - 4/8/16 are assigned to the output ports DMX 1 - 4/8/16.
[This is the recommended setting when using one MADRIX LUNA].
§
If you are broadcasting data for a large number of Universes [using Broadcast
Mode instead of using Unicast Mode] with MADRIX 5 or a 3rd-party controller for
example, you can assign different DMX universes to each LUNA device with these
settings. Each MADRIX LUNA will then only receive data from the specific universe
and send it to its specified output port.
Example: You can set up that LUNA 8 #1 only listens to Art-Net universe 1 - 8,
while LUNA 8 #2 listens to Art-Net universe 9 - 16, and LUNA 8 #3 listens to Art-
Net universe 17 - 24, and so on.
§
Universes are shown in hexadecimal notation and Art-Net Net switch / sub-net
switch notation in the Network Universe tooltips.
Channel Offset - Allows you to shift the received DMX universe [512 DMX
channels] per port if required.
§
This will modify the output.