AP-WRC4 Installation
With
EV-100 Evolution Autopilot
www.madmanmarine.com
Assumptions:
•
The EV-100 autopilot installation is, or will be installed, in accordance with the
Raymarine
EV-100 installation manual. As a guide, refer to Figure 1 for a typical EV-100 installation.
•
A Raymarine SeaTalk1 to SeaTalk
ng
converter is, or will be, installed in accordance with the
Raymarine SeaTalk1 to SeaTalk
ng
converter installation manual.
•
All required SeaTalk1 to SeaTalk
ng
conversion parts are present.
(All required parts, except for a
blue backbone cable, are included in the Raymarine E22158 converter kit, which is the recommended
kit to purchase if there is no existing SeaTalk1 to SeaTalk
ng
converter installed).
•
The AP-WRC4 is to be installed close to the SeaTalk1 to SeaTalk
ng
converter.
Steps:
1.
Turn off power to the EV-100 and 12V supply cable which supplies the SeaTalk
ng
backbone.
2.
Prepare the SeaTalk1 to SeaTalk
ng
cable from the E22158 converter kit by cutting off the
SeaTalk connector (see Figure 2) and stripping the cable back to expose the red wire, yellow
wire and the screen/shield that surrounds them.
(Optional: apply clear heatshrink over the twisted screen/shield and a larger piece of black heatshrink
over the cable end to make a neat job).
EV-1
Power
Supply
for
SeaTalk
ng
Controller
5-way Connector
Backbone
ACU100
ACU Power
To
Drive
Unit
Terminator
Terminator
Figure 1 - Typical EV-100 Installation
Figure 2 - SeaTalk Cable
Cut off this
connector.
Note yellow
connector on
SeaTalk cable.
(Do not cut!)
This 12V cable
only required
for ACU100!
