Installation Manual
240v Device Autor100
AUTOMATION BRIDGE
Page 1: ...Installation Manual 240v Device Autor100 AUTOMATION BRIDGE ...
Page 2: ...he heater and before the heater Must be fitted by a qualified person experienced with Connect 10 controllers as well as the heaters they are connecting to Is a 240v relay switch device used to transform 240v into a low voltage applicable communications 1 2 metre 3pin Plug 10 metre 2 core cable AutoR100 IMPORTANT REQUIREMENTS INCLUDED PARTS 2 ...
Page 3: ...Auto Relay into Heat Pump s Control connection 5 and 6 Terminals remove loop cable and replace with 2 core cable See image below Note it is not polarity sensitive can be installed either way into terminals 6 Heat pump will show OFF when connect 10 is not sending signal for heating 7 Set connect 10 temperature above current temperature and enable heating 8 Switch heat pump ON from controller and Se...
Page 4: ...perature Control 3 Select Display and control Genus and Connect Inbuilt then click Next 4 Under Choose primary heater type select your primary heater 5 Under Choose secondary heater type select your secondary heater then click Next 6 Click through the menu and make necessary changes and name your heater s 7 In the Channels setup select the Channel that will control power to this module Generally C...
