Product User Guide | 3
Event101A
PRODUCT USER GUIDE
LED Indicators
Green LED blinks:
10 seconds to indicate
logging and 15 seconds to indicate delay
start mode.
Red LED blinks:
10 seconds to indicate
low battery and/or memory and 1 second
to indicate an alarm condition.
Multiple Start/Stop Mode Activation
•
To start device:
Press and hold the pushbutton for
5 seconds, the green LED will flash during this time. The
device has started logging.
•
To stop the device:
Press and hold the pushbutton for
5 seconds, the red LED will flash during the this time.
The device has stopped logging.
Device Maintenance
Battery Replacement
Materials: Small Phillips Head Screwdriver and a
Replacement Battery (LTC-7PN)
1. Puncture the center of the back label with the screw
driver and unscrew the enclosure.
2. Remove the battery by pulling it perpendicular to the
circuit board.
3. Insert the new battery into the terminals and verify it
is secure.
4. Screw the enclosure back together securely.
Note:
Be sure not to over tighten the screws or strip the threads.
Recalibration
Recalibration is recommended annually. To send devices
back for calibration, visit
.
Engineering Units
Engineering units are used to convert one measurement
reading to another. The MadgeTech software allows for
software level Engineering Units (conversion applied to
data after download). Certain devices have device level
Engineering Units, which upon download automatically
appear in the chosen unit of measure. Please refer to the
Engineering Units Video on
for step-by-step setup instructions.
Alarm Settings
To change the settings for the alarm:
1. Select
Alarm Settings
from the
Device Menu
in the
MadgeTech Software. A window will appear allowing to
set the high and low alarms and warning alarms.
2. Press
Change
to edit the values.
3. Check
Enable Alarm Settings
to enable the feature
and check each high and low, warn and alarm box
to activate it. The values can be entered in the field
manually or by using the scroll bars.
4. Click
Save
to save the changes. To clear an active
alarm or warn, press the
Clear Alarm
or
Clear Warn
button.
5. To set an alarm delay, enter the duration of time into
the
Alarm Delay
box in which the readings can be
outside of the alarm parameters.
Set Password
To password protect the device so that others cannot
start, stop or reset the device:
1. In the
Connected Devices
panel, click the device desired.
2. On the
Device
Tab, in the
Information
Group, click
Properties
. Or, right-click the device and select
Properties
in the context menu.
3. On the
General
Tab, click
Set Password
.
4. Enter and confirm the password in the box that
appears, then select
OK
.