Users manual for Innowalk Pro 2
Version: 1.06
–
Version date: 06.12.2023
Page
63
of
78
7.10.2 Power supply
The Innowalk has a built-in power supply, and is connected to a wall outlet (110 - 230V AC) when
used. If the power supply is out of order, a new electronic box with power supply can be ordered
from Made for Movement and be installed by a MFM trained technician.
When electricity is connected to the product, please wait until a beep can be heard before using the
remote control.
Power supply specification
Type:
Protek
Model:
PM500F
Picture 56 - Connection of power supply
Disconnect device:
Disconnect the Innowalk by turning it off and pulling out the inlet power
to the Power supply. Always remember to disconnect the device after use.
Important:
Only the built-in power supply can be used!
7.10.3 Fuse, Indicator light
The Innowalk is equipped with a fuse at the right side of the motor cover. To inspect or replace this
fuse, turn the top of the fuse holder and remove the cap to get access to the fuse. If a replaced new
fuse burns over shortly after being changed, then contact your Made for Movement representative
to examine the product before it’s used again.
The indicator lamp have circulating colours when
power is connected, and the emergency switch is in its outer position. The Innowalk has power and
can be operated.
Picture 57 - Indicator lamp and fuse holder
Important:
Only use this fuse:
Connection of
power supply
Fuse holder
Indicator lamp