PM150-CO2 Portable Gas Monitor
REV – 1.0
[34-2900-0211-5]
12
|
P a g e
7.2
Clear Max (Peak Values)
To delete the measured peak concentration in the detector, follow below steps.
1.
Press the Function key & power button simultaneously and the Function key until CLr (max) is displayed.
2.
Press the power button to clear the peak value.
3.
After the successful activation, SUC (
V
) mark is displayed. If it fails, FA (
X
) mark is
displayed.
7.3
Clear STEL and TWA
To delete the measured STEL and TWA value in the detector, follow below steps:
1.
Press the Function key until CLr (STEL & TWA) is displayed.
2.
Press the power button to delete the TWA and STEL values
3.
After the successful activation, SUC with (
V
) mark is displayed.
7.4
Adjust Unit
To change the unit (ppm or %Vol) in the detector, follow below steps:
1.
Press the Function key until UnIt is displayed and power button to enter the mode.
2.
Press the Function key to select a unit (ppm or %Vol) and power button to save it.
3.
After the successful activation, SUC (
V
) mark is displayed. If it fails, FA (
X
) mark is displayed.
7.5
Factory Reset
To restore the factory setting, please follow below steps:
1.
Press the Function key until “InIt” is displayed.
2.
Press the power button to apply it.
3.
After the successful activation, SUC (
V
) mark is
displayed. If it fails, FA (
X
) mark is displayed.
