996553
–
Revision A
P a g e
|
15 of 17
Manually Traversing the Hoist along the Track
Always use extreme care when moving the hoist along the track. Watch out for and avoid any obstructions that may
cause injury to the individual in the sling, damage to the hoist and/or to the obstruction.
After use, the hoist should be located at the correct end of the track system for re-charging.
When needed, the hoist should be moved along the track to a position directly above the person using the following appropriate
method:
The operator shall lower the carry bar to a comfortable height so that it can easily be held by hand.
Gently pushing the carry bar, move the hoist along the track to the required position, where the person can be safely loaded
into the sling.
NEVER pull the hoist along the track using the handset or Emergency Lowering Cord as this could have a detrimental
effect on the performance of the hoist.
Charging the Hoist
The TX Hoist is charged by the charging dock installed in the track. A charging dock should have been fitted during the
installation of the Hoist.
To Traverse the TX simply traverse the Hoist along the track to the charging dock at the far end of the track. Once the Hoist has
made contact, it should begin charging immediately. The LED will begin to flash orange when charging, or if fully charged, will
show a steady gr
een. The LCD screen will display ‘charging’ or ‘charged’
.
At the end of each use of the Hoist, it is recommended that it be returned to the charging dock for placement and charging. This
will ensure that the batteries are charged on a regular basis for peak performance and maximum life expectancy.
Accessories
The Remaining parts in the box include the User Manual and the Allen key which is used for Manual Emergency Lowering of the
Hoist. These should be given to the customer for safe keeping. The Box should also be kept with the User and stored in a safe
place. The Box will be required for decommissioning and transportation.
Figure 37
Figure 38
