996553
–
Revision A
P a g e
|
12 of 17
Component Attachment
The section below will cover the attachment of the Carry Bar and Handset to the Hoist, as well as other essential requirements
to fully commission the Hoist for use. The below procedure is relevant for all TX Hoists.
A sturdy ladder or steps may be required in order to access the underside of the Hoist to attach the handset.
Attaching the Handset
In this section the correct procedure on attaching the Handset will be determined.
The Pneumatic Handset is attached to the Hoist through the Airline Grommet on the underside of the Hoist as shown in Figure
27. While holding the Airline Connector at the end of the Handset Air Tubes, locate the two small metal ribbed pins with the
Airline Grommet on the Hoist. To correctly locate, ensure the profile of the two parts are lining up, this means the grey rib
profile, which faces inwards on the Hoist aligns with the grey rib on the Handset, this is the only way the Handset can be
connected, therefore it is not possible to incorrectly mate the two parts.
Once the two parts have been aligned, ensure that the Handset is pushed into the Grommet properly, with both metal pins
being fully inserted into the Grommet. This is important to ensure there is no air leak which will affect the Hoist functionality.
To remove the handset, follow the procedure above in reverse.
Figure 27
Figure 28
Figure 29
