995064 – Revision A
Page 28 of 36
9.10 – Rear Castor
Within this section it will explain the correct procedure on removing and reinstalling the
Rear Castor for servicing procedures or replacement.
Removal
Step 1 – Remove the Foot Tray from the Base. (Refer to section 9.12)
Step 2 - Place the Stand Aid in its side for easier service – Gently rest the Stand Aid on its
side to avoid damage such as paint scratching.
Step 3 – To release the Rear Castor, place a 6mm Allen Key into the bolt and remove the
screw to release the Castor.
Refitting / Replacement
Step 4 - Refitting is a reversal of the removal process noting the following point:
A)
Ensure that the Castor is secured tightly, there should be no play after fastening.
B)
Ensure the Castor rotates freely.
C)
Ensure the washer is fitted.
