995068 – Revision A
Page 10 of 36
8.2 - Hoist doesn’t charge
Connect the Hoist charging lead from the Hoist to the Wall Socket. (Ensuring that the lead is
connected properly) to determine if the Hoist charges. If the control box LED does not illuminate a
steady orange, follow the Troubleshooting Guide below.
Troubleshooting Guide
1.
Check the Charger plug is turned on at the power supply.
2.
Check that the Charger Lead is connected correctly to the Control Box
3.
Check charging lead for damage, e.g. cuts and breaks.
4.
Check that the Battery is connected properly with the Control Box.
5.
Inspect the Battery terminals for any damage, e.g. burns and breaks.
6.
Inspect the Control Box terminals for any damage, e.g. burns and breaks
7.
Replace the charging lead.
8.
Replace the Battery
9.
Replace the Control Box
Action Guide
1.
Turn the Plug Switch at the wall on.
2.
Reattach the Charger Lead to the Control Box – See section 9.2.3 on Charger Cable
Attachment.
3.
Replace charging lead – See section 9.2.3 on Charger Cable Attachment.
4.
Connect the Battery correctly to the Control Box as shown in section 9.1.
5.
Replace the Battery. (see section 9.1)
6.
Replace the Control Box. (see section 9.3)
7.
See section 9.2.3 on Charger Lead replacement.
8.
See section 9.1 on Battery replacement
9.
See section 9.3 on Control Box replacement
8.3 - Hoist doesn’t lift
Attempt to raise/lower hoist with handset, but hoist is not responding. (The LCD displays the “up”
“down” function, LCD version only), For Hoists without the LCD, a response noise from the Control
Box should be noticeable. Follow the Troubleshooting Guide below.
Troubleshooting Guide
1.
Check if the Hoist is plugged into Charge. (Hoist will not raise and lower while on charge)
2.
Check that the Lift Actuator to Control Box cable is connected properly between the two
ports.
3.
Check the Lift Actuator to Control Box cable for damage, e.g. cuts and breaks.
4.
Inspect the Lift Actuator for any signs of damage which could affect its function, including
the Port. E.g. Large Cracks and breaks, electrical burns.
5.
Inspect the Control Box Port for any damage. E.g. electrical burns, breaks.
6.
Replace the Lift Actuator to Control Box cable.
7.
Replace the Control Box.
8.
Replace the Lift Actuator.
