FKDRM18S Flyware Kit Installation Instructions
Description
The contents of this kit allow the DRM18S powered subwoofer to be flown
below the FB100 Flybar. An additional DRM18S and up to four DRM12A
loudspeakers may also be flown below it. Each DRM18S requires its own
flyware kit (part number 2051056). Use this kit only with the DRM18S.
FKDRM18S Flyware Kit (Part No. 2051056) contents:
Item
Quantity
Description
A
2
Screw, M4.8 x 19mm Long
B
2
Rubber foot
C
4
Screw, M10 x 55mm Long
D
2
Fly Bar
E
2
Screw, M10 x 30mm Long
F
2
Lock washers, M10
G
2
Flat washers, M10
H
1
FB100 Rear Brace
I
2
Screw, M6 x 30mm Long
J
2
Lock washers, M6
K
2
Flat washers, M6
L
2
Nuts, M6
Required Tools (not included):
#2 Phillips screwdriver
6mm Hex driver
17mm open end or box wrench
Loctite 222
Safety First!
Before installing and using this product, please read these
instructions carefully and keep them on hand for future reference.
Additionally, refer to the DRM18S and DRM12A product manuals
and FB100 Flybar installation instructions for detailed product-specific
information, including complete post-rigging kit usage instructions.
Failure to follow the precautions in these documents may result in injury
or damage to the DRM18S, DRM12A and/or contents of the rigging kit.
It could also lead to injury – or even death! – to you.
WARNING:
This product has been designed for installation only
by qualified and licensed personnel having the technical know-how
and experience of the operations involved to prevent any risk to personal
safety. When installing this product, always respect the safety standard.
Do not install the product in any way that is not described in these
instructions.
WARNING:
The DRM18S rigging kit has been tested to a Working Load
Limit (WLL) of 452 lb / 205 kg with a design factor of 10:1. This rigging kit
may hold up to two DRM18S subwoofers [102 lb / 46.3 kg each] and four
DRM12A loudspeakers [62 lb / 28.1 kg each] in succession. Never apply
a load that exceeds the Working Load Limit.
Before suspending the loudspeaker(s), make all of the necessary
calculations to ensure that all of the components are used within
their nominal work load range. Remember that the weakest component
determines the safety level of the entire installation.
Flyware Kit Installation
1. Using the #2 Phillips screwdriver, place the threaded part of the screws
(A) through the rubber feet (B) and into the pilot holes on the bottom
of the DRM18S. Do not over-tighten the screws.
2. Using the 6mm Hex driver, remove the two screws on each side
of the DRM18S. Store these four screws in a safe place, as they
will be necessary should the rigging kit no longer be needed.
B
A
B
A