Mack V-MAC IV, Operator'S Handbook Manual

Page: 114 / 133

106 V-MAC Co-Pilot Operator's Manual
Maintenance
The MAINTENANCE submenu screen is accessed from the stationary MAIN MENU
2 screen (see) . To view the screens of the MAINTENANCE submenu, highlight
“Maintenance” with the stalk switch
Up & Down button and then press the Enter
(
↵ ↵ ↵
) button to select the screen.
The MAINTENANCE submenu screen contains the following main screens:
Displays the maintenance schedule for various maintenance items, such as engine oil
and coolant change. Maintenance items are displayed on the screen one at a time
as shown in . Maintenance items, when enabled in VCADS or MACKtraq, can be
reset after maintenance has been performed. If maintenance has not been performed,
resetting the maintenance item will be prohibited.
Maintenance Monitor
C0035402
Figure 53 — Maintenance Screens
GuardDog™ (optional; must be enabled)
GuardDog™, an active maintenance monitoring system, uses sensor readings to show
the status of routine maintenance requirements. If the vehicle is equipped with the
GuardDog™ system, Co-Pilot will display GuardDog™ related maintenance items
under the following conditions:
•
When the vehicle is started
•
During driving as individual maintenance items become due
•
Manually through the GuardDog™ Status screen
After power-up initiation and the MACK LOGO screen appearance, the Co-Pilot
will display the ACQUIRING DATA screen. After activation on this screen, if no
maintenance item is due, the GUARDDOG™ NO MAINTENANCE ITEMS DUE
screen will appear. However, if more than one maintenance item requires service, the
GUARDDOG™ MAINTENANCE interrupt screen (see) will appear. To view the due
maintenance items, select the GUARDDOG™ STATUS screen.
The GUARDDOG™ STATUS screen will display a list of GuardDog™ items and the
corresponding condition will be shown as “low,” “check,” or “OK.”
https://truckmanualshub.com/