Mack V-MAC IV, Operator'S Handbook Manual, Page: 131 / 133

V-MAC Co-Pilot Operator's Manual 123
CO-PILOT® OPERATIONS
This chapter is intended as a general overview to operations.
Using the Co-Pilot®
Note:
Turn the ignition key to the ON
position before operating the Co-Pilot®.
When the ignition key is turned to the ON position, the Co-Pilot® automatically
turns on. The MACK LOGO INTRO screen (refer to Figure 40) appears for several
seconds and is usually followed by the last Anytime screen that was active prior to
power-down. If vehicle management and control (V-MAC) IV is programmed to
“get driver” at key-on or for theft deterrence (refer to Figure 41), then the CHANGE
DRIVER screen (refer to Figure 52) will appear. Messages on the screen will prompt
the driver to press the
Enter ( ↵ ↵
↵
) button to accept the driver ID or use the Co-Pilot®
stalk switch to enter a password.
Remember to press and hold the
Enter (
↵ ↵
↵
)
button before beginning a trip to make the
stationary MAIN MENU screen appear.
Note: If the screen is black, press the Enter (
↵ ↵ ↵
) button on the stalk switch to turn it on.
Note: It is also possible to retrieve engine hours and odometer readings with the
ignition OFF; simply press and hold the Enter (
↵ ↵ ↵
) button on the stalk switch.
https://truckmanualshub.com/