4 Getting Started with FeverWarn l Models FW100, FW120, FW130, FW200 and FW230
MachineSense • Sales: +1-443-457-1165 • [email protected] • www.feverwarn.com
Connecting to the FeverWarn App
To connect to the MachineSense cloud and optionally, your local WiFi
network, you will need to download the FeverWarn Mobile Support
App from either the Apple App Store or Android Google Play Store
depending on the smart device you’ll be using to connect to the
FeverWarn scanner.
You will also need a cable with a USB type-A connector on one end
and the proper USB connector for whichever smart device you will
be using to conduct the setup on the other end. The newer Apple
devices will use a lightning connector, and modern Androids will use
USB Type-C. If you are using an older device, you may need a different
connector.
1. From your cellphone/tablet, navigate to the app store and search
for
“FeverWarn Mobile Support” for Android devices or
“MachineSense IoT Support App” for iOS (Apple) devices and
install
it following the directions for your device.
2. With the scanner powered up,
and the app running connect
your USB cable from your
device (phone/tablet) to
any available USB port on the
scanner
(Figure 6).
3. Go to
“Settings” on your phone
and turn on USB Tethering
(Android Figure 7) or Personal
Hotspot
(iOS Figure 8). This
allows the scanner to “see” the
internet through your cellphone/
tablet.
!
IMPORTANT: For iOS devices (Apple), Personal Hotspot must be
activated. Some Android devices may disconnect from WiFi (by
default) when attempting to connect with USB Tethering and Mobile
Hotspot (mobile data must be activated).
4. If prompted to “trust this computer” respond yes.
5. Your scanner should now be connected to the internet.
Figure 6: Connect a USB
cable from your device
to any available port on
the scanner.
Figure 7: Go to “Settings” on your
phone and turn on USB Tethering
(Android)
Figure 8: Go to “Settings” on your
phone and turn on USB Tethering
(iOS/Apple)
