MachineryGuide AutoSteer system installed always check that all parts of
the system is in operational condition, nothing is loose, damaged or missing.
15. If there is any doubt of the safety or reliability of the MachineryGuide
AutoSteer system contact the responsible expert or the MachineryGuide
team and do not use the system
16. Only turn on or off the MachineryGuide AutoSteer system when it is safe and
conditions are appropriate.
17. If any unusual or abnormal phenomenon is present after the MachineryGuide
AutoSteer system is activated (for example excessive heat from the motor
unit) turn off the system immediately and contact the responsible expert or
the MachineryGuide team.
18. The operator must have knowledge on how to react to different scenarios of
emergencies in relation with the MachineryGuide AutoSteer system.
19. Only trained personnel is allowed to carry on any maintenance or repair on
the MachineryGuide AutoSteer system. Always wear proper protective
prescribed personal protection equipment during installation, maintenance or
repair.
20. Only use original components to install, maintenance or repair the
MachineryGuide AutoSteer system is not stated otherwise.
21. Do not place objects on the parts of the MachineryGuide AutoSteer system.
Warning Alerts
The manufacturer and installer of the MachineryGuide AutoSteer system
disclaim any responsibility for damage or physical harm caused by the failure
to adhere to the safety requirements stated below:
1.
Read this documentation prior installing and operating the MachineryGuide
AutoSteer system to understand the potential associated hazards.
2.
Never leave the machinery’s operator seat while the MachineryGuide
AutoSteer system is engaged to avoid death or injury from being run over by
the vehicle or the automated motion of the steering system.
3.
To prevent accidental death or injury from being run over by the vehicle
make sure that the vehicle is clear of any obstacle or human while the
MachineryGuide AutoSteer system is active (including installation,
calibration and automatic steering operation).
4.
To prevent accidental engagement of the MachineryGuide AutoSteer system
and loss of vehicle control always make sure that the system is powered off
4
