Error messages
The MachineryGuide AutoSteer system displays different error messages via the
dedicated LEDs on the front panels of the devices. These messages can be decoded
by the following table:
NODE error messages:
Error LED
Cause
1
PWR
The device is under power.
2
ACT
A. Lights continuously if there is
communication with the app
B. Flashes every 3 second if no
communication
3
ERR
A. Lights continuously if there is no
NMEA data
B. Flashes every 3 second if there
is CAN overflow
AutoSteer error messages:
Error LED
Cause
1
INTERR
The AutoSteer function has been
interrupted by the user.
2
ERROR
A. Overheat: The led blinks
3 times
under a 3 second interval. (The
motor has overheated)
B. AngleSensor: The led blinks
1
time
under a 3 second interval.
(The AngleSensor is measuring at
its limit)
C. No target angle: The led lights
continuously
. (There is no target
angle received from the app)
D. CAN error: The led blinks
5 times
under a 3 second interval. (An
error occurred in the CAN
communication)
3
ACTIVE
The AutoSteering is turned on.
4
POWER
The device is powered up.
9