Instruction for use URYXXON
®
500
12
Instruction for use URYXXON
®
500 V 2.1 / 01.23
Connect the power cable
f
to the transformer
g
, and then
connect the transformer cable to the DC IN port (a) at the back of
the instrument. Connect the cable to a grounded outlet.
4.3 Connections / interface
Apart from the power connection
A
, the instrument has 4
additional interfaces (1 x USB
B
, 1 x PS/2
C
, 2 x RS232
D
) to
connect different devices or a laboratory information system (LIS)
(see above).
4.4 Insert printer paper
NOTICE
Only use special thermal printer paper!
To open the printer paper cover, press the little button above the
touch screen. Move the printer paper cover backwards.
Unroll appr. 10 cm (4“) of printer paper and place the printer
paper into the chamber, so that the paper unrolls downwards and
towards the touch screen.
Close the printer paper cover with an audible click, so that the
printer paper comes out from the chamber.
4.5 Switching on the instrument
You can find the On / Off switch
E
on the back of the instrument.
Turn on the instrument by pressing the switch (see pictures below).
Right after switching on, the instrument performs a self‑test. The
touch screen lights up and the start screen appears. The little light
above the transport tray turns green, thus signalling operational
readiness. If a serious error is detected during the self‑test, no
measurements can be performed. In this case, contact the
MACHEREY‑NAGEL technical service.
