Mace HydroMace XCi, Product Manual

Page: 66 / 270

The "WebComm Utility"
This utility provides the user with a simple diagnostic interface to communicate with the WebComm card in
order to test the settings and inititate a data upload on the MACE data server. The utility also has an handy
feature that enables direct AT command communication with the modem.
From the “
Device settings
” dialogue box click “
WebComm utility
” and the “
WebComm utility
” dialogue
box will appear.
NOTE: The " Set FTP Start " will only appear if FTP uploads have been enabled.
Test an HTTP Upload
NOTE: If this is your first " Upload ", you may need to run the " Initial upload
routine " described below
1. Click “ Start upload ” and the utility will “force” the WebComm card to talk to the data server and
upload any data stored in the log. A successful upload will be completed if all the “ Settings ” in the
WebComm card have been entered correctly and there is a cell network in range with sufficient signal
strength.
MACE XCi User Manual - 66 -